Exam : HP HP0-752
Title : ProCurve Mobility


1. You configure two access points (APs) to support a single wireless LAN (WLAN). One station associates with one AP, and one station associates with the other AP. What do the two stations have in common?
A. wireless cell
B. service set identifier (SSID)
C. basic service set identifier (BSSID)
D. independent basic service set identifier (IBSSID)
Answer: B

2. When does supplemental authentication occur?
A. after both the open-key 802.11 authentication and the 802.11 association are completed successfully
B. after both the shared-key 802.11 authentication and the 802.11 association are completed successfully
C. after the open-key 802.11 authentication is completed successfully but before the 802.11 association process begins
D. after the shared-key 802.11 authentication is completed successfully but before the 802.11 association process begins
Answer: A

3. Which statements describe 802.11a? (Select two.)
A. It interferes with 802.11b/g.
B. It requires support for 802.11h in Europe.
C. It experiences interference from microwaves.
D. It has higher data rates than 802.11b.
E. It was the first adopted and most widely used standard.
Answer: BD

4. What is one reason to choose ProCurve's Wireless LAN System over its standalone AP solution?
A. Your network requires many wireless devices that are managed from a central location.
B. You need your wireless network solution to provide RADIUS services.
C. Your network requires Layer 3 roaming and advanced authentication options.
D. You want to manage your wireless network using ProCurve Manager (PCM) Plus.
Answer: A

5. In which mode does the ProCurve Access Point (AP) 420 operate?
A. mixed-cell mode
B. in-cell relay mode
C. peer-to-peer mode
D. infrastructure mode
Answer: D

6. Which statement describes a closed system?
A. In a closed system, the wireless network name is encrypted in the 802.11 header.
B. In a closed system, the wireless network name cannot be detected in any 802.11 frames.
C. In a closed system, the wireless network name is not advertised in the 802.11 beacon frame.
D. In a closed system, the wireless network name is not included in the header of any 802.11 frames.
Answer: C

7. ProCurve Mobility Infrastructure Solutions help you meet the challenges posed by a wireless network (as compared to a traditional wired network). What is one of these challenges?
A. 802.11 standards do not provide any guidelines for Layer 2 roaming.
B. Studies have found that users tend to be less productive when they have mobile access to a network.
C. Multiple users connect to the network through the same access point (AP), but access must be customized for each user.
D. 802.11 standards do not provide any encryption, so you must create virtual private network (VPN) tunnels to each end station.
Answer: C

8. When configuring a Wireless LAN (WLAN) on the ProCurve Wireless Edge Services xl Module, you can use Normal mode or Advanced mode. Why would you use Advanced mode, rather than Normal mode?
A. You want to configure 16 WLANs.
B. You want to customize the transmit power for only one RP.
C. You want one WLAN to be supported on only one of the RPs.
D. You want the adopted Radio Ports (RPs) to beacon a WLAN that has an index number of 4.
Answer: C